Complete Kitchen Plumbing Solutions in Addison, IL
Whether you're just swapping out a faucet and hooking up a new dishwasher or planning a full kitchen renovation with sink relocation, gas line installation, and adding a prep sink, our crew can handle every detail. The size of your project affects the timeline, costs, and permit requirements, but we’re ready to tackle it all with precision.
My best tip? Get us involved early — before cabinets are installed. If the sink moves, it's best to reroute drains while the subfloor is exposed. Gas line installation must happen before your cabinets go in, especially for island cooktops. Pot fillers require wall access behind the stove, which is much simpler before backsplash tile is applied. Booking plumber time early can prevent costly delays, especially with our sometimes unpredictable Illinois weather.
We’re also available for routine kitchen plumbing needs outside remodels — faucet replacements, garbage disposal repairs, dishwasher hookups, or adding a water line for your fridge. Kitchen remodels are a great time to review your water heater capacity and get ahead of any drain clogs before cabinets are back in place. Reach out at 708-773-4149 to set an appointment.
What Kitchen Plumbing Services Do We Offer?
Sink and Faucet Installation
We fit all sink styles including undermount (which requires precise countertop cuts), drop-in, farmhouse, single or double bowls, and prep sinks. Our installation covers the drain basket, strainer, P-trap, and supply line connections. We always use braided stainless steel supply lines—these stand up to wear far better than old plastic ones. Garbage disposal hookups can be handled during the same visit if needed.
Faucets? We handle every configuration—single-hole, three-hole with deck plates, and more. Everything is pressure tested to avoid leaks. Moving a sink to a new spot involves rerouting drains and vents and extending supply lines. We take care of the permits and inspections so you don’t have to.
Dishwasher and Appliance Hookups
Dishwasher installation includes hot water line hookup and drain hose routing with an air gap or high loop to prevent backflow contamination, meeting code requirements. We check that the electrical supply is adequate in coordination with your electrician. For refrigerators with ice makers or water dispensers, we run dedicated cold water lines with shutoff valves tucked neatly behind the unit.
We also install instant hot water taps, under-sink filtration units, and reverse osmosis systems. For RO units, we handle the faucet installation, supply line connections, and waste lines, plus guide you on routine filter changes. Give us a ring at 708-773-4149 for any appliance plumbing needs.
Gas Lines for Kitchen Appliances
Whether you’re converting from electric to gas or adding a gas cooktop in a new island, we properly size and install the gas piping. We run the line from the nearest gas source, install shutoff valves, use approved flexible connectors, and test the system for leaks. Permits and inspections are taken care of by our team. Check our gas line services page for detailed info on safety and installation.
Important to remember: running new gas lines to an island or new stove location should happen before cabinets are installed. Adding piping afterward is tricky and costly. Coordinate this with your general contractor and our plumbers to keep the project smooth.
Pot Filler Faucet Installation
Pot fillers are wall-mounted faucets over your cooking surface, perfect for filling pots without lugging them across the kitchen. Installation requires running a cold water line inside the wall about 56 to 60 inches above the floor and just off-center from the stove. It's a fairly simple job during remodels when walls are open. For finished kitchens, we carefully open the wall, install the faucet, and patch the surface afterward. Contact us at 708-773-4149 to discuss your options.
Island Sink Drain and Vent Solutions
Island sinks need special drainage setups since they don’t connect to traditional wall vents. That means installing an island loop vent or an air admittance valve (AAV), depending on local codes. Supply lines are simple enough—just run hot and cold water to the island—but routing the drain and vent pipes under the floor and back up requires careful planning. We’ve handled many island sink installs and can help you work this into your kitchen design.
Kitchen Plumbing Checklist
- Removal and installation of kitchen sinks (undermount, farmhouse, drop-in)
- Faucet installation across all mounting types
- Garbage disposal setup or replacement
- Dishwasher water and drain line connections
- Refrigerator ice maker water line installation
- Gas line installation for ranges, cooktops, and ovens
- Pot filler faucet rough-in and final installation
- Under-sink water filtration or reverse osmosis system setups
- Drain and vent routing for island sinks
- Upgrade shutoff valves throughout the kitchen plumbing
- Installation of prep or bar sinks in pantry or island areas
Timing Tips for Kitchen Plumbing
- Confirm sink location before demolition: Sink relocation is costly; finalize placement before ordering cabinets.
- Gas line rough-in before cabinetry: Running new gas lines to islands or new appliance spots must happen early.
- Pot filler before backsplash installation: Easier to open the wall before tile goes up.
- Upgrade shutoff valves while plumbing is exposed: Replace old gate valves with durable ball valves when accessible.
- Fridge water line installation ahead of countertops: Running the ice maker line is simpler before countertops are set.
Common Questions About Kitchen Plumbing
Yes, but it’s one of the trickier plumbing jobs. Island sinks require special venting—either an island loop vent or an air admittance valve—to function properly. Running supply lines is straightforward, but the drain venting through the floor needs careful planning. We’ve done plenty of island sink installs, so call 708-773-4149 to discuss your layout before making a final decision.
If you’re just replacing fixtures in the same spots—like swapping faucets or disposals—permits usually aren’t needed. But anytime you reroute drains, add new supply lines, or work on gas piping, permits and inspections are required. We handle all permitting and inspection scheduling as part of our service.
Definitely. Installing gas lines is best done early in the remodel process while walls are open. We take care of sizing, pressure testing, and permit coordination. Visit our gas line services page for more info. Make sure to schedule this before the cabinets go in to avoid costly rework.
Yes, we often partner with general contractors and designers on kitchen projects. We coordinate our work around your project timeline and handle all the plumbing permits and inspections. Call 708-773-4149 early to get us scheduled alongside your team and keep things running smoothly.